| |
Marking & Measuring Tools
Dial calipers - fractional & digital fractional, self-stick
tape rules, squares, straight edges, calipers, dividers, drawing tools
gauges, trammel points, French curves and many other measuring and marking tools for your
workshop.
 
It didn't exist so we had it made for us! One turn of the
dial equals an inch, a feature that no other dial caliper has.
Measures to 6-1/2"
Calibrated in 64th's of an inch
Caliper is machined from hardened stainless steel for long life
Dial indicator is shock proofed
Comes in a foam padded molded case
When "just about" isn't close enough, The Wixey Dual
Display Digital Caliper is the ONLY fractional caliper available that
displays both the fraction and the decimal equivalent AT THE SAME TIME.
Because other fractional digital calipers round up or down to the nearest
fraction, you never know if you are exactly on your fractional measurement.
You could be larger or smaller by the amount the caliper rounds. The only
way to ensure 100% accuracy is by toggling back and forth between the
fractional display and the decimal display, which is tedious and most often
only increases the opportunity for error. With these calipers you can read
the fraction and the decimal equivalent at the same time so you know that
1/2" is exactly .5", not .51" or .49". This may not seem like much until you
look at the gap around the edge banding you just inlaid into a one-of-a-kind
table!
12" Combination Square. Four piece set includes rule,
combination, center and protractor heads. All the tools you need for
virtually any layout project. The satin finished, hardened, 12" blade
features extra fine graduations in 8ths, 16ths, 32nds, and 64ths. All three
heads are precision ground cast iron, finished in baked enamel.
Take exact measurements at-a-glance with our adhesive
backed rules. Precision steel, ready to mount on table saws, work benches,
sewing tables, lathe beds or wherever you constantly need to check
measurements. 1/2" wide tapes can be easily cut to shorter lengths. In 6'
and 12' lengths reading left-to-right or right-to-left to meet your shop
needs.
Pinnacle Precision Straight Edges offer an accuracy of
better than .001" per foot, which means the variance over the length of the
48" straight edge is less than 1/256". Now that's accurate! Accuracies at
this level really become important when setting up your table saw wings or
jointer and planer infeed and outfeed tables. Each Pinnacle straight edge
starts out as a slab of hot roll steel. Hot roll is better than cold drawn
because of its reduced internal stresses, and it is less likely to deform
when ground.
Once the part has undergone a stress relieving heat treat process, it is
carefully ground on a massive surface grinder to extreme tolerances on all 4
sides. Finger slots are cut for easier handling and each tool is inspected
on a certified granite surface plate to ensure its straightness. Each
straight edge is 1/4" thick x 2-3/8" wide. Available in 24" and 48" lengths.
Each comes with a wall mountable MDF case and is made in the U.S.A.
Marking Tools
Measuring Tools
A successful project begins with accurate measuring tools. From calipers and depth gauges to angle finders and steel rules, we stock a complete selection of tools designed to make your woodworking as precise as possible.
Thanks for shopping here. Come again.
|
Wixey Dual Display Fractional Digital Calipers
WOODCRAFT Squares
Self-Stick Tape Rules
Pinnacle Precision Steel Straight Edge
